If the service suspension light appears, then it is not a big problem but it can definitely be an expensive one to repair! Hi i have a 2011 gmc yukon denali and the service suspension system indicator keeps coming on and i replaced both rear air shocks, is there something that has to be reset.
6.2l so i have been reading a ton and just starting to look around.
Service suspension system light reset. Does anyone know how i can reset the service ride control light without going to the dealer? The car sits a lot in the garage, only out for church and the grocery store, etc. Aug 18, 2015 #4 02burgundybeast full access member.
An expert that got 5 achievements. O.k.,here is the manual procedure on how to clear/erase the fault codes in the suspension system.you will need to select rss or elc to erase these codes in this procedure.keep in mind if there is still a fault detected with the suspension system components the light/message may come right back on again until the problem is corrected and then. The ride control warning signals when the escalade computer system detects something is wrong with the suspension.
My service light came on saying, check suspension system. When checking for dtcs, the esc module will have dtc c0711 set. This time it didn’t and i wanted it documented so i dropped it off.
#6 · oct 26, 2016. There is a “service suspension system” message on the dic and the rear suspension ride height may be lower than normal under a heavy payload. The easy to use tool allows a novice to reset service intervals and oil lights along with reading and clearing any faults from the dme or systems like psm, air bag, hvac, suspension, traction system, etc.
Use this to decipher and post any found codes. Turn the ignition switch to the on position (do not start engine). The service suspension system appears everytime she starts the car.
On the cadillac escalade, this warning can be reset two ways depending on whether the ride control warning is showing due to electrical problems or due to a mechanical problem. You may find that one or more suspension control electrical connectors are unplugged/dirty/wet. The model was introduced to the public at the new york international auto show in april 2012 and was first launched in the us in june 2012, before it appeared on the.
Problem i found with the arnott system is the resisters seem to work although 2 years ago the ones i got needed connectors or soldering. If the fault is in the. This year the same thing happened for the first week or so, now the light is on all the time.
The downfall here is the rest of the suspension system must be maintained and working or the fault codes still happen It has come on twice before but always reset once restarting the truck. Trying to find an easy way, not to go to the dealer, and figure out what's the issue.
Press and release the brake pedal two times. Unplug batt awhile or use diagnostic tool. Fully depress the accelerator pedal slowly two times within 10 seconds.
Is this s… my mother owns a 2000 cadillac sts with low mileage (25k). How do i reset the service suspension light on a 2014 zl1 camaro? Each spring when i take the car out the light flickers and sometimes stays on, usually disconnecting the battery resets it.
Posted on nov 22, 2018. It is very much drivable. An expert that got 10 achievements.
Yes, my 3500 is currently in the shop due to the service air suspension light. I have not heard the compressor come on but have been the only one in the truck since replacing the rear shocks and have not had any weight in the vehicle. This condition may be caused by an internal fault in the alc pressure sensor.
If you still have any questions, then comments down below. Codes read out as a letter, 4 digits, a letter. I guess i don't know the advantage other than cheaper shocks.
There was a stored code that they cleared, the csaid it wasn’t an active code so they wouldn’t / couldn’t do anything. Have the car's diagnostic trouble code system scanned at any large parts store. The service suspension system light came on this.
With this guide on how to reset service suspension system, you can troubleshoot the system. The service suspension system msg only comes on intermittently with no real rhyme or reason for doing so. The icarsoft por v2.0 diagnostic tool is a professional grade tool at a fraction of the cost of a durametric or piwis tool.
Electronics, if they're going to fail, fail more often in the first weeks of use, or tend to last years before failure. You might be able to turn the system off and eliminate the warning light. To reset the “perform service” indicator system (after performing the scheduled maintenance) refer to the following procedure:
There have been a few cases of the ram air suspension system failing early on due to a sensor failure or the control module itself. That vehicle has the air ride system, which means there is a small compressor, air lines, sensors and air assisted suspension, so you could have an air leak, listen for the air compressor running to see if it's running excessively, you could have a bad air ride sensor , you could have a bad compressor, a basic hand held obd ii scanner cannot pick up the air ride trouble codes, you need a gm.